This allows the concrete shell to be heated hydronically the same way radiant concrete floors are done.
The tubing was installed by wire-tying it to the remesh in the pool shell just before the concrete was poured.
What you cannot tell from the photos, is that they all contain PEX tubing in the floors and walls of their concrete shells. They are located near Pecos, Taos and Galisteo, New Mexico, respectively.
#Solar radiant floor heating cost professional
These were installed by professional pool builders using standard in-ground concrete shells that were site-built. Take a look at the pools shown in the photos in Figure 50-1 (A, B and C). You can see at the bottom of the diagram that a pool or spa heating zone is often included on a pair of ‘closely spaced tees’ either indoors or outdoors as required by the job. Figure 71-2 shows a block diagram of our typical standard primary loop configuration. In fact, in a number of systems built in recent years, the pools have been connected the same way as any other radiant heated floor. (Archives and links to past articles can be found on the websites of Plumbing Engineer, PHC News and SolarLogic LLC.)Ī pool or spa can be treated much like any other heating zone when tied into a standard primary loop. This is especially easy to accomplish when the hydronic solar heating system is constructed using a “New Standard” primary-loop configuration as described many times in this column. One of the most popular and practical uses for “extra” solar heat in summer is to heat a swimming pool without the use of fossil fuel.
0 kommentar(er)
